Hi

To get a seat at BITS Pilani or Hyderabad, you need to meet the cutoff released by the institute. The cutoff is the minimum marks required to get admission at the institute and the preferred course. Please note that cutoff for both the campuses will vary, also it will be different for different engineering programmes and categories.

The closing rank of BITSAT 2016 cutoff for the Pilani campus for various engineering programmes is as follows:

Chemical Engineering - 319

Civil Engineering – 314

Electrical & Electronics Engineering – 362

Mechanical Engineering – 346

Manufacturing Engineering – 311

Computer Science Engineering – 384

Electronics & Instrumentation Engineering - 345

The closing rank of BITSAT 2016 cutoff for the Hyderabad campus for various engineering programmes is as follows:

Civil Engineering – 303

Mechanical Engineering – 316

Computer Science Engineering – 347

Electrical & Electronics Engineering – 324

Chemical Engineering – 298

Electronics and Communication Engineering -332

Manufacturing Engineering – 298

Electronics & Instrumentation Engineering - 313

I would advice you to not set these closing ranks as your target, instead prepare well and perform better in the exam. You will get through the entrance exam if you are well prepared.

All the very best!

According, to Careers 360 BITSAT 2018 cut off  will be determined by the below factors

• Number of candidates in BITSAT 2018

• Previous years criteria of cutoff selection

• Difficulty level of BITSAT 2018

• Highest score in the entrance examination

• Average marks secured by all examinees

You can check the BITSAT 2016 cut off below

BITS Pillani- 384

BITS Hyderabad- 347

Try to score more then 384 marks in your BITSAT exam

Good luck!!